OXYGEN SENSOR PLATE OMC VOLVO/PENTA(1994 UP) OUT DRIVE V-6 V-8 CHEVY

Description

CALL WITH ANY QUESTIONS 517-975-4770
OTHER 02 PLATES FOR MARINE APPLICATIONS AVAILABLE
Oxygen Sensor Installation Plate.  BRAND NEW ALUMINUM  For OMC (Pre 1994 OMC Out drives) VOLVO PENTA 1994 AND NEWER ON VOLVO PENTA MOST V-8 and V-6 engines
THIS PLATE IS FOR ALL VOLVO PENTA OUTDRIVES FROM 1994 TO PRESENT
THIS PLATE FITS THESE GASKET NUMBERS
If you have a gasket #
SIERRA#  18-0943, 18-4431-9
OMC # 909786,  3850496
GLM# 33810
2 GASKETS INCLUDED WITH THE 02 PLATE
Use this to install an oxygen sensor on your OMC VOLVO PENTA engine.  Aftermarket EFI (Electrionic Fuel Injection) systems need an oxygen sensor to run in closed loop for maximum performance and fuel economy.  The O2 sensor needs to be installed in the exhaust stream to sample exhaust gases.  The computer reads the oxygen sensor and readjusts the injector flow and ignition timing for maximum efficiency.   The oxygen sensor plate can also be installed on a carbureted engine. With a wide band O2 sensor and dashboard gauge, air/fuel ratios can be read for precise carburetor jetting.  The oxygen sensor plate easily installs between the stock Exhaust manifold and riser.  The plate is threaded for a standard O2 sensor, which screws into the side of the plate (O2 sensor not included).  The plate is 4 3/4" x 3 1/4" and the bolt holes are 3.90" x 2.60"
Approximately Center to Center
The plate is 1" thick and 2 GASKETS ARE INCLUDED